Canon iR6570 series, Portable Manual

Page: 85 / 320

Chapter 3
3-1
3.1 Error Code Details
3.1.1 Detail Error Code
0009-6176
iR5570 / iR6570
T-3-1
Code Description Remedy
E000 The heater fails to heat.
After correcting the fault, be sure to reset the error.
(COPIER>FUNCTION>CLEAR>ERR)
0000 After power-on, the reading of the main
thermistor does not increase to 70 deg C or
higher within 20 sec.
- Replace the main/shutter thermistor.
- Replace the DC controller PCB.
0010 The power has been turned off and then on
without resetting the error.
- Reset the error.
(COPIER>FUNCTION>CLEAR>ERR)
E001 There is an abnormal rise in temperature.
After correcting the fault, be sure to reset the error.
(COPIER>FUNCTION>CLEAR>ERR)
0001 There is an error or an open circuit in the
main thermistor, shutter thermistor, or sub
thermistor.
- Check the connector of each thermistor
for any fault in connection and wiring.
- Replace the thermistor in question.
- Replace the DC controller PCB.
0002 The reading of the main thermistor, shutter
thermistor, or sub thermistor is 230 deg C
or higher for 2 sec.
- Replace the thermistor in question.
- Replace the DC controller PCB.
0003 The reading is not 150 deg C or higher or
210 deg C or lower within 30 sec.
- Turn off and then back on the power.
0010 The power has been turned off and then
back on without resetting the error.
- Reset the error.
(COPIER>FUNCTION>CLEAR>ERR)
E002 There is an abnormal rise in temperature.
After correcting the fault, be sure to reset the error.
(COPIER>FUNCTION>CLEAR>ERR)