Canon iR6570 series, Portable Manual

Page: 86 / 320

0000 The reading of the main thermistor is not
100 deg C 12 sec after it has exceeded 70
deg C.
- Check the connector of the main/shutter
thermistor for any fault in connection and
wiring.
- Check the main/shutter thermistor for
mounting condition.
- Replace the main/shutter thermistor.
- Replace the fixing heater unit.
- Replace the DC controller PCB.
0001 The reading of the main thermistor is not
150 deg C 15 after it has exceeded 100 deg
C.
0010 The power has been turned off and then
back on without resetting the error.
- Reset the error.
(COPIER>FUNCTION>CLEAR>ERR)
E003 There is an abnormal rise in temperature.
After correcting the fault, be sure to reset the error.
(COPIER>FUNCTION>CLEAR>ERR)
0000 The reading of the main thermistor is
lower than 70 deg C for 2 sec or more after
it has exceeded 100 deg C.
- Check the connector of the main/shutter
thermistor for any fault in connection and
wiring.
- Check the main/shutter thermistor for
mounting condition.
- Replace the main/shutter thermistor.
- Replace the fixing heater unit.
- Replace the DC controller PCB.
0010 The power has been turned off and then
back on without resetting the error.
- Reset the error.
(COPIER>FUNCTION>CLEAR>ERR)
E004 The IH power supply is faulty/the IH control mechanism is faulty.
After correcting the fault, be sure to reset the error.
(COPIER>FUNCTION>CLEAR>ERR)
0101 There is a mismatch between the input
voltage and the IH power supply ID.
Replace the fixing heater power supply
with one designed for the country of
installation (voltage).
Code Description Remedy