Canon iR6570 series, Portable Manual

Page: 102 / 320

0001 At time of power-on, the communications
IC on the main controller PCB does not
become ready within 3 sec after start-up.
- Check the connection of the cable.
0002 At time of power-on, the communications
IC on the DC controller PCB cannot be
initialized.
E711 There is a fault in the IPC communication.
0001 After power-on, the occurrence of an error
has been written 4 times in 1.5 sec to the
error register of the communications IC on
the main controller PCB.
- Check the connection of the cable.
0002 After power-on, a fault has been detected
by the communications IC on the DC
controller PCB.
E713 There is a fault in the communication with the finisher.
0000 A fault has been detected in the
communications IC on the finisher side.
- Check the connection of the cable.
- Replace the finisher controller PCB.
- Replace the DC controller PCB.
E717 There is a fault in the communication with the NE controller.
After correcting the fault, be sure to reset the error.
(COPIER>FUNCTION>CLEAR>ERR)
0001 An error has occurred at time of NE
controller start-up.
The NE controller that was connected
before power-off is not connected at
power-on.
- Check the connection of the cable.
0002 There is an IP error while the NE controller
is in operation.
The IPC may have an open circuit or the
IPC communication cannot be recovered.
E719 There is a fault in the coin vendor.
After correcting the fault, be sure to reset the error.
(COPIER>FUNCTION>CLEAR>ERR)
Code Description Remedy