Canon iR6570 series, Portable Manual

Page: 103 / 320

0001 An error has occurred at time of coin
vendor start-up.
The coin vendor was connected before
power-off, but is not connected at power-
on.
- Check the connector of the cable.
0002 An IPC error has occurred while the coin
vendor is in operation.
The IPC may have an open circuit, or the
IPC communication cannot be removed.
The pickup/delivery signal line has an
open circuit.
An illegal connection has been detected.
0003 While a unit price is being obtained at
start-up, an error has occurred in the
communication with the coin vendor.
0011 An error has occurred at card reader start-
up.
The card reader that was connected before
power-off is not connected at power-on.
0012 An IPC error has occurred while the card
reader is in operation.
The IPC may have an open circuit, or the
IPC communication cannot be recovered.
E730 There is a fault in the PDL software.
1001 There is an initialization error. - Execute PDL resetting.
- Turn off and then on the main power.
100A An error has occurred that can be fatal to
the system (e.g., initialization error).
9004 There is a fault in the PAI communication
with an outside controller.
- Turn off and then back on the main
power.
- Check the open I/F board and cable
connection.
- Replace the external controller open I/F
board.
- Replace the main controller PCB.
9005 There is a fault in video connection with an
external controller.
A006 absence of PDL response: there is no PDL
response because of a fault in or the
absence of Subbootable.
- Execute PDL resetting.
- Turn off and then on the main power.
- Check the connection of the SURF
board.
- Re-install the firmware.
- Replace the main controller PCB.
Code Description Remedy