Canon Inner Finisher-K1, Service Manual

Page: 80 / 114

3. Set A4 or LTR paper on the processing tray unit.
4. Fit the paper [1] to the leading edge [2] of the rear alignment plate.
5. Measure the gap [a] between the leading edge [3] of the front alignment plate and the edge of the paper.
CAUTION:
Because the front alignment plate is installed a bit tilting toward the delivery direction, set the paper to be fitted to the leading
edge.
[2]
[1]
[a]
[3]
6. Enter the gap value measured in the above step 5 in the calculation formula below, calculate the adjustment value.
Adjustment value = gap (mm) x 10 - 50
NOTE:
Correspondence table of measured gap value and adjusted value
Gap mm (measured
value)
Adjustment value Gap mm (measured val-
ue)
Adjustment value
1.5 -35 3.5 -15
2.0 -30 4.0 -10
2.5 -25 4.5 -5
3.0 -20 5.0 0
7. Enter the adjustment value and press OK key.
8. Copy 10 sets of 1 original and confirm that an alignment failure and a delivered paper failure do not occur.
9. In case failure occurs again, repeat steps 1 and 8.
10. Remove paper on the processing tray.
11. Enter the values of service mode items recorded on the service label of the finisher rear cover.
5. Adjustment
74