■ Alignment Operation in Staple Mode
1. After the delivery sensor (PS1) detects the trailing edge of the paper, the front and rear alignment plates move to the wait
positions.Explanation for 2-point stapling will be omitted because it is the same as the center alignment operation in Non-
sort mode.
• Front 1-point stapling (front alignment plate position: paper width position (148.5 mm), rear alignment plate position:
paper width + 5 mm)
Rear Alignment Plate
End of Paper
+5 mm
Middle of Feeding Path
148.5 mm
Front Alignment Plate
• Rear 1-point stapling (front alignment plate position: paper width + 5 mm, rear alignment plate position: 148.5
mm)
Rear Alignment Plate
End of Paper
+5 mm
Middle of Feeding Path
148.5 mm
Front Alignment Plate
2. Move the front and rear alignment plates to align the paper.
5mm
5mm
Middle of Feeding Path
Rear Alignment Position
Front Alignment Position
■ Alignment Operation in Staple-free Staple Mode
Explanation for staple-free staple mode will be omitted because it is the same as the center alignment operation in Non-sort mode.
2. Technical Explanation
28
Summary of Contents for Inner Finisher-K1
