Canon IMAGERUNNER 7086, Service Manual

Page: 581 / 615

Chapter 18
18-21
5) While downloading is under way, the control
panel screen shows its progress. At the end of
downloading, a message will appear asking you
to press a key. Press the appropriate key. If the
machine is in normal mode, the shut-down
sequence will start.
F-18-58
6) When a message appears asking you to turn off
the power, turn off the main power, remove the
USB device, and turn the main power switch
back on.
7) Upon start-up, the machine starts writing the
system software to the system area of the HDD
or the flash ROM. At the end of writing, a
message will appear asking you to turn off and
then back on the power. Turn off and then on
the main switch.
F-18-59
18.4.4.6 Formatting the HDD
0011-6781
This function is available only when the machine
is in safe mode.
[4]: Format HDD (in the presence of BOOT-
DEV)
Use it to format the HDD for BOOTDEV parti-
tion.
[4]: Format HDD (ALL) ( in the absence of
BOOTDEV, as when replacing with new HDD)
Use it to format the HDD for full partition.
<Procedure>
Go through the following to format the HDD for
BOOTDEV partition:
1) If the machine is on, go through the HDD shut-
down instructions, and turn off the main power.
2) Connect the USB device to the USB port.
3) Start up the machine in safe mode.
4) Follow the instructions on the control panel,
and press the appropriate key.
[4] -> [0]: go to Partition Selection screen /
other that [0]: go back to Menu screen
F-18-60
5) Go through the instructions on the control
panel, and press the appropriate key.
[1] -> [0]: execute BOOTDEV formatting /
other than [0]: go back to Menu screen
[C]: go back to Menu screen
F-18-61
6) At the end of formatting, a message will appear
asking you to press a key. Press any key to go
back to the Men screen.
F-18-62
7) Start downloading the system software. For
instructions, see "Downloading the System
Software."