Canon ImagePRESS Server H350 V2, Service Manual

Page: 65 / 117

3. Remove the power supply cable from the hard disk drive.
4. Remove the hard disk drive data cable from the hard disk drive.
5. Remove the screw securing the hard disk drive bracket to the bracket shelf.
6. Slide the hard disk drive bracket off the shelf and lift it out of the chassis.
Unlock the hard disk drive bracket by moving the latch toward the connector panel, and then sliding the bracket off the bracket
shelf.
IMPORTANT:
Avoid striking the DIMMs as you remove the hard disk drive bracket.
NOTE:
You will encounter slight resistance as you slide the bracket off the shelf. The resistance is caused by two tension points on the
bottom of the bracket. The resistance helps control the bracket’s movement during removal and installation.
1
2
3
4
5
Figure 34:Removing/replacing the hard disk drive bracket
No. Item No. Item
1 Tension points 4 Shelf
2 Latch 5 Screw
3 Hard disk drive bracket
NOTE:
Printer interface board and internal cables are not shown.
4. REPLACING PARTS
58