40
OSD Menu
Item
Setting Options (underline indicates factory default)
LUT Delete
Deletes imported LUT.
LUT Type (Gamma, Color Gamut)
: Select the LUT type.
Select LUT
: Selects User LUT 1-8.
Delete
: Deletes LUT.
2020 Constant
Luminance
Sets the color matrix conversion method to be used when "ITU-R BT.2020" is selected for "Picture
Mode".
Constant Luminance
: YUV signals are linearly converted and then converted into RGB signals.
Non-constant Luminance
: YUV signals are converted into RGB signals without changing gamma
0.45.
Note
• SD-SDI is fixed to "Non-constant Luminance".
2020 Gamut
Mapping
Set this item when "ITU-R BT.2020" is selected for "Picture Mode" or when "User 1-7" or "Canon
Log" is selected for "Picture Mode" and also "ITU-R BT.2020" is selected for "Color Gamut".
Gamut Mapping
: Mapping is performed on colors outside the native color gamut by Canon's
unique method.
Clipping
: Colors outside the native color gamut are clipped by a general method.
Calibration
Performs calibration based on set target values when "User 1-7" is selected for "Picture Mode".
Luminance
: Sets the target luminance.
48
to
150 (100)
cd/m
2
Color Temperature
: Sets the target color temperature.
D93, D65, D61, D60, D56, D50, DCI-P3
: Select from preset color temperatures.
Custom (xy)
: You can adjust CIE x, y in increments of 0.001.
x: 0.260
to
0.360 (0.313)
/
y: 0.260
to
0.360 (0.329)
Color Gamut
: Sets the color gamut.
SMPTE-C, EBU, ITU-R BT.709, ITU-R BT.2020, Adobe RGB, DCI-P3
Gamma
: Sets the target gamma.
2.2, 2.35, 2.4, 2.6, ITU-R BT.1886
Start
: Performes calibration.
Note
• When "Luminance" is set to high brightness, it may be calibrated beyond the brightness
adjustment range and set lower than the target value depending on the "Color Temperature"
setting. In that case, set the "Luminance" again.
Copy
Picture Mode
When "User 1-7" is selected for "Picture Mode", the content of the selected picture mode is copied.
The following modes can be selected:
Picture Mode
: SMPTE-C, EBU, ITU-R BT.709, ITU-R BT.2020, Adobe RGB, DCI-P3, User 1-7 (other
than the currently set parameter)
Execute
: Performs copy.
Picture
Mode Name
You can change the name of "User 1-7" within 16 characters including alphabetical characters,
numbers, and symbols.
Anchor Adjustment
Temporarily saves parameters for adjusting "Contrast", "Brightness", "Chroma", and "Sharpness"
and recover the values (anchor point setting).
OK
: Performs anchor point setting.
Cancel
: Returns to the previous screen without setting anchor point.
Reset
Return "Picture Mode" to factory default. Note that in "User 1-7" mode where you are performing
calibration, the setting returns to the value after calibration instead of the factory default.
When selected, the message "Reset Adjustment settings to defaults?" appears.
OK
: Performs reset.
Cancel
: Returns to the previous screen without resetting.
