14
Installation/Connection
Mounting the Main Unit on a Stand or Wall
This main unit can be fitted to a stand* or to a wall mount bracket*. Remove the stands beforehand (
Screws compatible with this main unit are M4 x 7 mm (VESA Standard 100 x 100 mm).
* Commercially available.
CAUTION
• For safety, make sure to perform this step with at least two people.
• When mounting the main unit on a wall, make sure the wall has sufficient strength. If necessary, apply reinforcement. Also,
make sure to check the load capacity of the stand or wall mount bracket.
• When the video display is placed on a rack or display stand and ventilation around it is blocked by equipment placed
above or below or in a surrounding area, the operating temperature may increase, causing a failure or overheating. In order
to maintain the operating temperature condition of the video display (0 ˚C to 40 ˚C), make a space of at least 1U (4.4 cm)
above and below and at least 4 cm space from its back. Make a sufficient space from peripheral equipment, secure vents,
or install a ventilation fan.
• When installing the video display on a wall, make sufficient space from the wall so that cables are not squeezed or twisted.
• When mounting a commercially available stand or wall mount bracket, be sure that they do not contact the carrying
handle.
• Avoid touching the screen during this step as it may damage it.
• Make sure that the main unit does not fall during installation/removal.
1. Attach a commercially available stand or wall mount bracket using four screw holes on the back or side
face of the main unit (
The screw hole size is shown below.
Rear
4×M4
7 mm deep (Max.)
2×M4
8 mm deep (Max.)
Same on the other side
Side
