D. PC Software Installation
To install the software for a Genie-2000 (Windows 95/NT) system, refer to the first
subsection below. To install the software for a Genie-PC (OS/2) system, refer to the
second subsection.
Installing the Genie-2000 Software
1.
If you are installing this software as an upgrade, make sure that no
Genie-2000 software is running, including the VDM.
2.
Put the disk labeled “Genie-2000 2016 Setup Software” in your floppy drive.
3.
Open a DOS Prompt (command) window and type
x:\setup
where “x:” is the floppy drive designator.
4.
To complete the installation, just follow the simple instructions you’ll see on
the screen.
Installing the Genie-PC Software
1.
If you are installing this software as an upgrade, make sure no Genie-PC
software (including the VDM) is running.
2.
Put the disk labeled “GENIE-PC AIM SFT Driver” into your floppy drive.
3.
Open an OS/2 window session and, at the system prompt,y> type the
following commands:
a:
cd 2016
setup
If you are using drive b:, make that your first command.
4.
Follow the simple instructions provided by the software to complete the
installation.
49
