CamRanger Hardware
!
The CamRanger device is turned on by sliding the power switch, located on the side of the unit,
towards the front of the device. The green power light will illuminate when the unit is powered
on. Any addiMonal switch present on the CamRanger currently serves no funcMon.
!
The charging port is located next to the power
switch. The male micro B end of the provided
white charging cord is connected to this port. The
other end of the charging cord can be connected
to a female USB port that provides power, such as
a computer or through the provided AC adapter.
!
When the device is charging, an addiMonal yellow
light will illuminate next to the green power light
indicaMng that it is charging. The yellow light will
turn off leaving only the green power light when it
is fully charged.
!
The CamRanger baRery is accessible by removing the boRom cover. The boRom cover is the
side with the CamRanger serial number. Simply grasp the side edge/corner of the cover near
the USB connector and pull back to remove. To replace the cover, first place the two lower tabs
into the slots and then snap in the top.
!
!
A black neoprene case is provided to assist in aRaching and securing the CamRanger, note that
this pouch is not waterproof. The case has a carabineer to facilitate hanging from a tripod, belt
loop, etc. Do not just hang the CamRanger by the cable as it will put strain on the USB
connectors as well as possibly disconnect.
!
Any switch on the opposite side of the power switch does not currently have any func5onality.
3
© CamRanger – Patent Pending
