Hot and cold pipe insulation installation
For increased energy effciency, use pipe insulation. Please install the insulation,
according to the illustrations above, making sure to insulate all the way to the top.
Do not cover any drain or pressure valve(s).
Hot Water
Inlet Pipe
Cold Water
Check Valve
Gas Inlet
NOTICE: The hot and cold pipes should be insulated as shown help to
provide additional freeze protection.
During Installation of This Water Heater
Do’s
●
DO check inlet gas pressure to ensure that it is within the range specified on
the rating plate.
●
DO provide adequate air for combustion and ventilation as discussed in the
Use & Care Manual and the National Gas Code .
●
DO maintain proper clearances to combustibles as specified by applicable
code.
●
DO ensure that the flue terminal location complies with the guidelines found in
the Use & Care Manual and National Fuel Gas Code.
Don′t s
●
DON’T block or restrict Air Intake Opening located on the back side of the
water heater.
●
DON’T remove the front cover unless absolutely necessary. This should only
be done after being examined by a qualified service technician.
●
DON’T install this product where standing water may occur.
1
28
Visit Us: Camplux.com
3330-A Marathon Ct Charleston, SC 29418
1(844) 538-7475
Summary of Contents for WA686M-NG
Page 2: ......
Page 83: ......
Page 84: ...Visit Us Camplux com support camplux com 3330 A Marathon Ct Charleston SC 29418 1 844 538 7475...
