● The included remote control can be placed in a convenient location in a
bathroom, however, AVOID areas where water may come into contact with the
control(s).
● Avoid areas where the remote control(s) may be exposed to heat, e.g. stove
ranges or heaters.
● Avoid areas where the remote control(s) may be subjected to oil and/or steam
from cooking.
● Avoid areas where chemical agents (such as thinner, benzine and alkaline) are
used.
● Avoid areas of direct sunlight.
● The MAXIMUM distance between the water heater and the remote control(s)
installation location is limited to 50 feet.
● No other manufacturer’s controls are suitable for use with this water heater.
● DO NOT attempt to disassemble the remote control.
Remote Control-Connection, Installation and Set
(For Panel Control/Remote Control and Remote Control units)
Panel Control/Remote Control and Remote Control units will work with either one
or two remote controls. If two remotes are desired, a wire connector will need to
be provided. To connect the remote control:
1. For one control: Plug the aviation joint into the socket directly on the water
heater (see illustration below).
Remote Control
Aviation Joint
Aviation Joint
2. For two controls: First, cut off the aviation joints on the two controllers, plug one
into the socket on the water heater (length is dependent on your requirements),
and throw away the other. Then connect the wires of the aviation joint to the
inlet wire of the connector, and connect the two remote control to the outlet
wires of connector.
1
52
Visit Us: Camplux.com
3330-A Marathon Ct Charleston, SC 29418
1(844) 538-7475
Summary of Contents for WA686M-NG
Page 2: ......
Page 83: ......
Page 84: ...Visit Us Camplux com support camplux com 3330 A Marathon Ct Charleston SC 29418 1 844 538 7475...
