Below are instructions for draining water out of the water heater.
1. Turn off the switch on the remote control.
2. Close the gas shut-off valve(s).
3. Close the water shut-off valve.
4. Turn the on/ off switch to the OFF position and disconnect breaker at least 10
seconds after step #1.
5. Open drain valve.
6. Open all hot water faucets. Before proceeding to the next step, make sure that
COLD water is coming out of all hot water faucets.
7. To put the water heater back into operation after draining, follow the steps
below.
8. Reinstall the water filter. Close the hot water outlet drain valve.
9. Open the water shut-off valve and close again after making sure that water
comes out from hot water faucets. (This step is to remove air from the water
lines.)
10. Reconnect the breaker and turn the on/off switch to the ON position, fully
open the gas shut-off valve and the water shut-off valve.
NOTICE: The water heater may not operate unless the above procedure is
followed correctly.
Before You Call For Service
Troubleshooting tips
Save time and money! Review the charts on the following pages first and you
may not need to call for service.
This water heater incorporates a variety of shut off devices that prevents the
operation of the water heater down if undesirable combustion conditions occur.
Such as the presence of a blockage of the combustion air vent insufcient
pressure which can impact the safe operation of the water heater. Please contact
a Qualified Service Technician if this occurs.
1
70
Visit Us: Camplux.com
3330-A Marathon Ct Charleston, SC 29418
1(844) 538-7475
Summary of Contents for WA686M-NG
Page 2: ......
Page 83: ......
Page 84: ...Visit Us Camplux com support camplux com 3330 A Marathon Ct Charleston SC 29418 1 844 538 7475...
