Set temperature memory
1. This model can memorize and save the last set temperature on the remote
control with “priority”.
2. If no remote control has “priority”, the set temperature of the unit will be the
same as the set temperature of the remote control which starts the water
heater.
● This water heater contains an electronically controlled thermostat. From the
factory, the temperature range is between 90°F and 140°F.
● The remote control is factory preset to 110°F.
● To turn the remote control ON or OFF, press the POWER button for more than 3
seconds.
● To adjust the temperature to a required setting, in“priority” mode, press the UP
or DOWN temperature button. Press and hold UP or DOWN to raise or lower
the temperature continuously.
● When the unit is in use, the set temperature can increase to 122°F, but there is
no limit to temperature decrease. To increase the temperature more than 122°F,
the water will need to be shut off first.
● The display will read the set temperature if the water heater is not in use or
there is no water flow. If the water heater is in use or has water flow, the display
will read the actual temperature. To view the set temperature in this condition,
press UP or DOWN and the set temperature will flash for 3 seconds.
● The hottest temperature water will be at the hot water faucet closest to the
water heater
● Always remember to test the water temperature with your hand before use and
remember that hotter water increases the risk of scald injury.
● Always supervise young children or others who are incapacitated.
● If the water heater has been subjected to fire, flood or physical damage, turn off
the manual gas shut-off valve(s), and do not operate the water heater again
until it has been checked by qualified personnel.
NOTICE: If inlet water temperature is high, and set temperature is low, the actual
temperature might be higher than the set temperature, and vice versa..
WARNING: Should overheating occur or the gas supply fail to shut off,
turn off the manual gas control valve to the water heater.
NOTICE: If the BATH control ls turned on, the temperature setting on the
MAIN control cannot be changed. The BATH control(s) will always have
PRIORITY over the MAIN control.
63
Visit Us: Camplux.com
3330-A Marathon Ct Charleston, SC 29418
1(844) 538-7475
Summary of Contents for WA686M-NG
Page 2: ......
Page 83: ......
Page 84: ...Visit Us Camplux com support camplux com 3330 A Marathon Ct Charleston SC 29418 1 844 538 7475...
