Output temperature of water is regulated by setting the temperature on the front
of the remote control.
Safety factors should be considered when selecting the water temperature setting
of the water heater’s remote control. The remote control was set at 110°F before
the water heater was shipped from the factory. This is the recommended starting
point.
Water temperatures above 120°F can cause severe burns or death from scalding.
The thermostat is adjusted to its lowest temperature position when shipped from
the factory.
Be sure to read and follow the warnings outlined in this manual and on the label
located on the water heater.
Mixing valves are available for reducing point of use water temperature by mixing
hot and cold water in branch water lines.
Procedures for adjusting the thermostat for energy efficient operation at the
minimum water temperature setting consistent with the consumer’s needs.
Contact a licensed plumber or the local plumbing authority for further information.
Water Temperature Setting
DANGER:
There is a hot water scald potential if the temperature is set
too high. Households with small children, disabled, or elderly persons may
require a 120°F. or lower temperature setting to prevent contact with HOT
water.
120°F
Water Temperature
Time To Produce a Serious Burn
More than 5 minutes
1 1/2 to 2 minutes
About 30 seconds
About 10 seconds
Less than 5 seconds
Less than 3 seconds
About 1 1/2 seconds
About 1 second
125°F
130°F
135°F
140°F
145°F
150°F
155°F
Table courtesy of Shriners Burn Institute
1
62
Visit Us: Camplux.com
3330-A Marathon Ct Charleston, SC 29418
1(844) 538-7475
Summary of Contents for WA686M-NG
Page 2: ......
Page 83: ......
Page 84: ...Visit Us Camplux com support camplux com 3330 A Marathon Ct Charleston SC 29418 1 844 538 7475...
