Campbell SkyVUE 8, Product Manual

Page: 16 / 116

FIGURE 1-1. Location of laser warning label
Before removing the laser module, the sensor must be disconnected from both the mains supply
and the battery to ensure that the laser is turned off.
1.5 Electrical safety
Because the sensor is powered from potentially hazardous mains voltages, the power-supply
should be wired only by personnel qualified to install electrical equipment. For permanent
outside installations, this usually requires a certified electrician who is also familiar with local
electrical and safety legislation. Some general guidance is given in
Connectors and wiring (p. 18),
but the responsibility for the installation lies with the installer.
The unit is tested for electrical safety before dispatch but may need subsequent testing according
to local practice.
NOTE:
The unit should only be serviced by trained personnel.
SkyVUE™8 (CS136) LIDAR Ceilometer 4