Cambium Networks PMP 450 AP, Configuration Manual

Page: 101 / 649

Chapter 1: Configuration General configuration
Page
1-73
Attribute Meaning
Ethernet Port
Selection Ethernet Port selection is applicable to the 450m platform only with two
choices in the drop-down list:
• Main: A selection of main indicates that link connectivity and power to
the 450m is provided through the RF45 connection on the Main port of
the AP
• SFP: A selection of SFP indicates that link connectivity will be provided
through the SFP port on the 450m
Power continues to be provided via the RJ45 Main port
Link Speeds From the drop-down list of options, select the type of link speed for the
Ethernet connection. The Auto settings allow the two ends of the link to
automatically negotiate with each other the best possible speed, and check
whether the Ethernet traffic is full duplex or half duplex.
However, some Ethernet links work best when either:
• both ends are set to the same forced selection
• both ends are set to auto-negotiate and both have capability in least one
common speed and traffic type combination.
Ethernet Link This parameter allows the operator to enable or disable Ethernet Link.
Ethernet Bounce
Timeout This parameter allows the operator to configure Ethernet bouce timeout
ranging from 0 to 60 minutes. Value 0 disables Ethernet bounce timeout.
802.3at Type 2 PoE
Status and
When the PoE Classification functionality is enabled and if Type 2 power is
not present, the PAs do not power up and draw too much power.
By default, the PoE Classification feature is disabled and the PAs will power
up regardless of the classification presented by the power source.