Cambium Networks PMP 450 AP, Configuration Manual

Page: 47 / 649

Chapter 1: Configuration Quick link setup
Page
1-19
If you enter a time and date, the format for entry is
Figure 8 Time and date entry formats
Time:
hh
/
mm
/
ss
Date:
MM
/
dd
/
yyyy
where
hh
represents the two-digit hour in the range 00 to 24
mm
represents the two-digit minute
ss
represents the two-digit second
MM
represents the two-digit month
dd
represents the two-digit day
yyy
y
represents the four-digit year
Proceed with the time setup as follows.
Procedure 5 Entering AP/BHM time setup information
1 Enter the appropriate information in the format shown above.
2 Then click the Set Time and Date button.
Note
The time displayed at the top of this page is static unless your device is
set to automatically refresh
Powering the SM/BHS for test
Procedure 6 Powering the SM/BHS for test
1 In one hand, securely hold the top (larger shell) of the SM/BHS. With the other hand,
depress the lever in the back of the base cover (smaller shell). Remove the base cover.
2 Plug one end of a CAT5 Ethernet cable into the SM PSU port
3 Plug the other end of the Ethernet cable into the jack in the pig tail that hangs from the
power supply
4 Roughly aim the SM/BHS toward the AP/BHM
5 Plug the power supply into an electrical outlet
Warning
From this point until you remove power from the AP/BHM, stay at least as
far from the AP/BHM as the minimum separation distance specified in
Calculated distances and power compliance margins in chapter 11.
6 Repeat the foregoing steps for each SM/BHS that you wish to include in the test.