CAKEWALK UA-1G, Owner'S Manual

Page: 26 / 64

26
Driver installation and settings
9.
The screen will indicate “Click Restart to finish installing the software.”
Click [Restart] to restart your Macintosh.
* It may take some time for your Macintosh to restart.
10.
After your Macintosh has started up, connect the UA-1G to the
Macintosh. Set the UA-1G’s [ADVANCED DRIVER] switch to the ON position, and then
connect it to the Macintosh.
942
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after
connecting the USB cable is required before the unit will operate normally.
Next, you need to set your software so it can use the UA-1G.
In order to use the UA-1G with your software, you’ll need to select the UA-1G as the audio
input/output device. For details on how to do this, refer to the documentation for your
software.
* The “44.1kHz” in the device name will depend on the setting of the UA-1G’s [SAMPLE
RATE] Switches (p. 13).
* If you’re unable to select the UA-1G as the audio input/output device in your software, it
may be that a problem has occurred. Refer to “Troubleshooting” (p. 40).
Using the UA-1G with iTunes
Some software, such as iTunes, will use the audio input/output device that you select in the
“Sound” preference settings.
Here’s how to specify the UA-1G as the sound output device so that it can be used with
iTunes.
* In a later step, you’ll use iTunes to play back sample data. Be sure to make the settings
described below.
* The content displayed may differ depending on your system.
Input/output device settings
Audio output device UA-1G 44.1kHz
Audio input device UA-1G 44.1kHz
Operation of the UA-1G
UA-1G_e.book 26 ページ ２００８年１２月１０日 水曜日 午後２時５０分