Cadillac 2010 SRX, Owner'S Manual

Page: 261 / 470

Driving and Operating 8-17
Ignition Positions
The vehicle has an electronic
keyless ignition with push
‐ button
start.
Pressing the button cycles it through
three modes, ACC/ACCESSORY,
ON/RUN/START and OFF.
If the push-button start is not
working, the vehicle may be near a
strong radio antenna signal causing
interference to the keyless entry
system. See
Driver Information
Center (DIC) on page 4 ‑ 29 for
more information.
To shift out of P (Park), the vehicle
must be in ACC/ACCESSORY or
ON/RUN mode and the brake
pedal must be applied.
OFF: When this button is pressed
with the engine running, the engine
will be turned off.
If the vehicle is in P (Park), the
ignition will turn OFF, and Retained
Accessory Power (RAP) will remain
active. See
Retained Accessory
Power (RAP) on page 8 ‑ 18 for
more information.
If the vehicle is not in P (Park),
the ignition will return to ACC/
ACCESSORY and display the
message
“ Shift to Park ” in the
Driver Information Center (DIC).
See
Driver Information Center (DIC)
on page 4 ‑ 29 for more information.
When the vehicle is shifted into
P (Park), the ignition system will
switch to OFF.
ACC/ACCESSORY: This position
allows you to use some electrical
accessories when the engine is off.
With the ignition off, pressing the
button one time without the brake
pedal applied, will place the ignition
system in ACC/ACCESSORY.
The ignition will switch from
ACC/ACCESSORY to OFF after
five minutes to prevent battery
run down.
ON/RUN/START: This position is
for driving and starting. With the
ignition off, and the brake pedal
applied, pressing the button once
will place the ignition system in
ON/RUN/START. Once engine
cranking begins, release the button.
Engine cranking will continue until
the engine starts. See
Starting the
Gasoline Engine on page 8 ‑ 18 for
more information. The ignition will
then remain in ON/RUN.