9-34
Vehicle Care
8. For the base vehicle, turn the
vertical aiming screw (V1) until
the headlamp beam is aimed to
the horizontal tape line. Turn it
clockwise or counterclockwise
to raise or lower the angle of
the beam.
For the up-level vehicle, turn the
vertical aiming screws (V1 and
V2) simultaneously until the
headlamp beam is aimed to the
horizontal tape line. Turn them
clockwise or counterclockwise to
raise or lower the angle of
the beam.
9. Make sure that the light from the
headlamp is positioned at the
bottom edge of the horizontal
tape line. The lamp on the
left (A) shows the correct
headlamp aim. The lamp on the
right (B) shows the incorrect
headlamp aim.
10. Repeat Steps 7 through 9 for
the opposite headlamp.
Bulb Replacement
For the proper type of replacement
bulbs, see
Replacement Bulbs on
page 9
‑
43
.
For any bulb changing procedure
not listed in this section, contact
your dealer/retailer.
Halogen Bulbs
{
WARNING
Halogen bulbs have pressurized
gas inside and can burst if you
drop or scratch the bulb. You or
others could be injured. Be sure
to read and follow the instructions
on the bulb package.
Summary of Contents for 2010 SRX
