Cadel aquos 15, Installation, Use And Maintenance Manual

Page: 89 / 232

89
AQUOS - IDRON
EN
ANOMALY POSSIBLE CAUSES SOLUTIONS
Pellets are not being fed into the
combustion chamber.
The pellet hopper is empty Fill the hopper with pellets.
Sawdust has blocked the feed screw
Empty the hopper and remove the
sawdust from the feed screw by
hand.
Faulty gear motor Replace the gear motor.
Faulty electronic board Replace the circuit board.
The fire goes out or the appliance
stops automatically.
The pellet hopper is empty Fill the hopper with pellets.
The pellets are not fed See the previous anomaly.
The pellet temperature safety probe
has been triggered
Let the product cool down, restore
the thermostat until the problem is
resolved and switch the product
back on. If the problem persists
contact Technical Assistance.
The door is not closed properly or the
gaskets are worn
Close the door and replace the
gaskets with original ones.
Unsuitable pellets
Change the type of pellets with
those recommended by the
manufacturer.
Low pellet supply
Have the fuel flow checked following
the booklet instructions.
The combustion chamber is dirty
Clean the combustion chamber,
following the booklet instructions.
Clogged outlet Clean the smoke duct.
Faulty smoke extraction motor
Check the motor and replace it, if
necessary.
Pressure switch faulty or defective Replace the pressure switch.
The product works for a few minutes
and then switches off.
Start-up phase is not completed Repeat start-up.
Temporary power cut Wait for the automatic restart.
Clogged smoke duct Clean the smoke duct.
Faulty or malfunctioning temperature
probes
Check and replace the probes.
Faulty spark plug
Check the spark plug and replace it,
if necessary.
Pellets accumulate in the brazier, the
glass of the door gets dirty and the
flame is weak.
Insufficient combustion air.
Clean the brazier and check that
all the holes are clear. Perform a
general cleaning of the combustion
chamber and the smoke duct.
Check that the air inlet is not
obstructed.
Damp or unsuitable pellets. Change the type of pellets.
Faulty smoke evacuation motor.
Check the motor and replace it, if
necessary.
The smoke evacuation motor does
not work.
No electrical supply to the stove.
Check the mains voltage and the
protection fuse.
The motor is faulty.
Check the motor and capacitor and
replace them, if necessary.
Defective motherboard. Replace the electronic board.
Control panel broken. Replace the control panel.