Cabletron Systems SSIM-A2-01, Installation And User Manual, Page: 77 / 88

68
SmartStack SSIM-A2-01/SSIM-A8-01
46 Call setup cleared by network or remote user.
47 Link is not active (being started).
49 Call failed because protocol is being reset (by user).
4A Link failure (during call setup).
4B Remote user signaling state mismatch.
4C Received message from remote user with protocol error.
4D Temporary out of local signaling resources.
4E
Remote user does not understand the call setup parameters.
The cause code is only valid if a cause Information Element (IE) has been received
from the network. If no IE cause was received, a zero cause code is shown. The
cause code is defined by the relevant UNI implementation agreement
(see the table below).
Action: Depending on the error and cause codes.
UNI Cause Codes
1
Unallocated (unassigned) number
2 No route to specified transit network
3 No route to destination
4 VccTimeOut
10 VPCI/VCI unacceptable
13 MultiCastSend VccType
16 Normal call clearing
17 User busy
18 No user responding
21 Call rejected
22 Number changed
23 User rejects all calls with calling line identification restriction (CLIR)
27 Destination out of order
28 Invalid number format
30 Response to STATUS ENQUIRY
31 Normal, unspecified
35 Requested VPCI/VCI not available
36 VPCI/VCI assignment failure
37 User cell rate not available
38 Network out of order
41 Temporary failure
43 Access information discarded
45 No VPCI/VCI available
47 Resource unavailable, unspecified
49 Quality of Service unavailable
51 User cell rate not available
57 Bearer capability not authorized
58 Bearer capability not presently available
63 Service or option not available, unspecified