Cabletron Systems SmartSwitch 6500, Reference Manual

Page: 232 / 358

2-208 SmartSwitch 6500 Reference Manual
2 p›F
If you hot-swap a TSM with a TSM of a different type (different I/O ports), port
configuration of the originial TSM is deleted. Before you insert a replacement
TSM, you can display existing port configuration using the
show
operator with the
/o
option (for example:
show portconfig /o
).
In the Output Parameter table below, (
</d>
) indicates parameters that are available only through the
show portconfig
/d
(detailed) command. The display shows both current and configured state of the parameters.
[MaxVpiBits] Maximum number of VPI bits. 0-6 No default
[MaxVciBits] Maximum number of VCI bits. 6-12 No default
[MaxSvcVpci] Maximum VPCIs available for SVCs. 0-[2
(MaxVpiBits)
- 1] No default
[MinSvcVci] Minimum VCIs available for SVCs. 32-[2
(MaxVciBits)
- 1] No default
[MaxVccs] Maximum number of VCCs available. 32-2
(MaxV MaxVciBits)
No default
[MaxSvpVpci] Maximum number of VPCIs available for
SVPs. 0-[2
(MaxVpiBits )
- 1] No default
[MaxVpcs] Maximum number of VPCs. 0-2
(MaxVpiBits)
No default
Output Parameter Description
[Port Name] Port number on the switch. (Same as the [PortNumber] input parameter.)
[Intf Type] Interface type. (Same as the [InterfaceType] input parameter.)
[Sig Type] Type of signaling on the port. Possible values are: autoConfig, uni30, uni31, uni40,
iisp30, iisp31, pnni10, pvcUni, pvcNni.
[ILMI State] ILMI status of the port. Possible values are: Up or Down.
[Trans Type] Type of physical interface.
[Media Type] Type of media.
Input Parameter Description Value/Field Size Default