Chapter 3: Installation
3-2
DLEHF-MA User’s Guide
3.3
DLEHF-MA OPTIONS
If the DLEHF-MA is to be installed with an optional Fast Ethernet
Interface Module, refer to Appendix C for installation instructions. The
installation instructions for the HSIMs available for the DLEHF-MA are
located in the associated HSIM user’s guide.
3.4
INSTALLING THE DLEHF-MA INTO THE DLM6C-AA
CHASSIS
The DLEHF-MA can be installed in any of the 5 slots that are available.
To install the module, proceed as follows:
1.
Remove the blank panel covering the slot in which the module will be
installed. All other slots must remain covered to ensure proper airflow
and cooling. (Save the blank plate in the event you need to remove the
module.)
2.
Carefully remove the module from the shipping box. (Save the box
and packing materials in the event the module must be reshipped.)
3.
Locate the antistatic wrist strap shipped with the DLM6C-AA chassis.
Attach the antistatic wrist strap to your wrist and plug the cable from
the antistatic wrist strap into the ESD grounding receptacle at the
upper right corner of the DLM6C-AA.
Install any optional equipment before proceeding to
Section 3.4.
!
Failure to observe static safety precautions could cause
damage to the DLEHF-MA. Follow static safety handling rules
and properly wear the antistatic wrist strap provided with the
DLM6C-AA chassis.
!
Do not cut the non-conductive bag to remove the module.
Damage could result from sharp objects contacting the board
or components.
