High Speed Interface Configuration Screen
DLEHF-MA User’s Guide
5-75
5.23.1
Configuring a DELTX-UI or DELF3-UI
in Port 1 or 2
When a DELFX-UI or a DELF3-UI is installed in port 1 or 2, it must be
manually set to operate in the same technology as the device at the other
end of the connected segment. Section 5.23.2 provides instructions for
manually configuring the port with a DELFX-UI or DELF3-UI interface.
5.23.2
Setting the DELFX-UI and DELF3-UI
Desired Operational Mode
Use this field to set the active technology. This field toggles between
100Base-FX and 100Base-FXFD (full duplex). To set the active
technology through Local Management, proceed as follows:
1.
Use the arrow keys to highlight the Desired Oper. Mode field.
2.
Use the SPACE bar to select 100Base-FX or 100Base-FXFD (full
duplex).
3.
Press ENTER. The port now operates in the chosen mode.
4.
Use the arrow keys to highlight the SAVE command. Press ENTER.
The message “SAVED OK” displays and Local Management saves
the changes to memory.
5.23.3
Configuring a DELTX-UI in Port 1 or 2
In normal operation, a port (1 or 2) with a DELTX-UI interface
automatically establishes a link with the device at the other end of the
segment and no user setup is required. Section 5.23.4 and Section 5.23.5
provide instructions for manually configuring the port with a DELTX-UI
installed.
5.23.4
Setting the DELTX-UI Desired Operational Mode
Use this field to set the active technology. This field toggles between
Auto-Negotiation, 10Base-T, 10Base-TFD (full duplex), 100Base-TX,
and 100Base-TXFD (full duplex). If Auto-Negotiation is selected, the
DELTX-UI automatically sets the active technology. To manually set the
active technology through Local Management, proceed as follows:
1.
Use the arrow keys to highlight the Desired Oper. Mode field.
