CAB THARO Apollo Series, Operator'S Manual

Page: 133 / 139

E-1 cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.
Appendix E - Firmware Updates
General Updates
The firmware of the Apollo printer series is subject to constant development,
e.g. a growing variety of features available, easier fault correction, etc.
In Apollo 1/2, the firmware is stored in an EPROM which for up-dating
purposes must completely be replaced with a new one. The replacement
should only be performed by Technical Service. The instructions are included
in the service manual.
In Apollo 3, the firmware is stored in a flash-EPROM, which represents a new
technology. For updates, only a file containing the up-dated version needs to
be copied via interface.
The file may be distributed on a disk or else is available on the Internet.
The cab and THARO Internet addresses are included in our latest brochures.
Firmware Updates Apollo 3
1. In Setup mode, set the serial interface of the Apollo 3 on the highest
possible speed that is supported by your computer, or else use the
Centronics interface.
2. When switching the Apollo 3 ON, press all of the four function keys at
once.
The display will show "SYSTEM UPDATE".
3. Transmit the data to the printer. Under DOS, use the following copy
command: COPY AP3_XXX.FMW COM2: /b.
4. During processing, the printer display indicates the progress with a " . "
after each block completed. (total number of blocks is 11)
After completing the copy process the display shows "OK", and all LEDs
are flashing. This also indicates the completion of the up-dating. Switch
the printer OFF.
5. In the event of an error during the up-dating process, the error code will be
shown in the display :
'C' : Check sum error (possibly "/b" missing in COPY command or file
faulty)
'H' : Header fault (possibly "/b" missing in COPY command or file faulty)
'E' : EPROM could not be deleted
'V' : Programming voltage too low
'P' : Programming fault
NOTICE !
If any one of the faults described above occurres, the previous firmware
setting is invalid and the programming has to be started again.