CAB THARO Apollo Series, Operator'S Manual

Page: 60 / 139

60 cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.
Cut Position
Using the optional cutter, the "Cut position" parameter allows you to alter the
distance between the cutting edge and the rear edge of the label. Normally,
with the initial offset value of "0" the cutting edge is in the middle of the gap
between two labels. Adjustments have to be carried out only once after a
cutter has been installed. (range from -.33 to +.33 in or -8.4mm to +8.4mm) If
the cut position value is positive, the media will be advanced before it is cut,
that means there is a greater distance between the cutting edge and the rear
edge of the label.
NOTICE !
It is recommended that you carry out changes for single print jobs in the
software. (e.g. if the cut is not wanted in the middle of the gap)
The software provides a second value for individual adjustments.
You may also change this value using the software commands. Any front
panel value and software command value are totaled together for printing.
The current field to be changed is flashing in the display.
4 Interface
6 Peel Position
5 Cut Position
Cut Position
+ x.x mm
Cut Position
- x.x mm
Cut Position
± 9.x mm
Cut Position
± 0.x mm
Cut Position
± x.9 mm
Cut Position
± x.0 mm
*
*
*
*
*
*
Cut Position
± x.x mm
Yes
Cut Position
± x.x mm
No
Confirmation
Sign (+ or -)
1/10 mm mm
Fig. 9 f Set "Cut Position" parameter