CAB THARO Apollo Series, Operator'S Manual

Page: 77 / 139

77 cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.
1 Firmware Version
Type of device, part number, and date of the firmware version.
2 Setup and Status Information
Country : Setting of the "Country" parameter
Print mode : Setting of the "Transfer print" parameter
Label sensor : Setting of the "Label sensor" parameter
Interface : Setting of the "Interface" parameter
Cut Position : Setting of the "Cut position" parameter
Peel Position : Setting of the "Peel position" parameter
Printhead Pos. : Setting of the "Printhead position" parameter
Heat level : Setting of the "Heat level" parameter
Test result : Result of the system test.
Any errors will be shown coded as four digit
hexadecimal numbers. (see Table 10)
(for fault correction see Appendix C)
/C shows when the setup has been altered from the
defaults. (Apollo 1 and Apollo 2 only)
For Apollo 3, the letter behind the "/" sign indicates
the state of modification of the hardware. (board)
Operative time : Cumulative operating time of the printer
Number of labels : Cumulative amount of printed labels
Thermal transfer : Cumulative length of printed material in thermal
transfer mode
Thermal direct : Cumulative length of printed material in direct thermal
mode
Date/Time : Setting of system date and system time
Character set : Setting of the "Character set" parameter
Temperature : Printhead temperature
Heat voltage : Current value of heat voltage
(approx. 24V / Apollo 3/300M approx. 20 V)
Brightness : Service information on brightness used at gap sensor
Peripheral device : Type of device connected to peripheral port
Memory card : Type and capacity of memory card (PCMCIA/PC card)