CAB THARO Apollo Series, Operator'S Manual

Page: 95 / 139

95 cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.
Inserting the Labels for Internal Rewind
1. Lift printhead by turning the lever (5) clockwise until it stops.
2. Loosen knurled screw (9), then swing the media retainer (8) backwards.
3. Place the media roll (6) onto the media hub (7). Swing the media retainer
(8) to the media hub and inwards until it rests against the side of the roll
(roll will slightly be slowed down when unwound).
Tighten knurled screw (9).
4. Slide the two media guides (13/14) outwards to their outermost position.
5. Unroll a length of stock from the media roll and feed along as shown in
Figure 13 m.
It is particularly important to ensure that the media strip slides properly
between the fittings of the adjustable photocell assembly (15).
6. Feed the media strip between the print roller and the thermal printhead,
and then over the rewind guide plate (3) to the internal rewinder (12).
7. The internal media rewind hub (12) is fitted with an expanding axle that
contains clamps (10) for securing the media. Slide the media strip from
underneath the rewinder clamps (10) to the disc. Fasten the media strip to
the axle by holding the rewinder and rotating the knurled knob (11)
clockwise until it stops. To tighten the media, rotate rewinder counter-
clockwise.
8. Slide the media guides (13/14) towards the edge of the media strip.
9. Lock the printhead by turning the lever (5) counter-clockwise until it stops.
NOTICE !
If you do not use the printer for an extended period of time, lift the
printhead to avoid possible flattening of the print roller.
Fig. 13 m Inserting the labels
5 6 7 8 9
10 11 12 13 14 3 15