CAB THARO Apollo Series, Operator'S Manual

Page: 127 / 139

C-5 cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.
Possible cause
There are labels missing on the
label material
The label format as set in the
software does not correspond with
the real label format
Printer is loaded with continuous
paper but the software is set on
labels
Out of label material
Label has not properly been loaded
in the label sensor fittings
The sensors of the label edge
sensor are positioned outside of the
path of the material
Out of transfer ribbon
Ribbon melted during printing
The printer is loaded with thermal
labels for direct thermal mode
(without transfer ribbon); but the
software is set for transfer printing.
Solution
Press key repeatedly until
printer recognizes the next label on
the material.
Cancel current print job.
Change the label format set in the
software. Restart print job.
Cancel current print job.
Change either software setting or
print media. Restart print job.
Insert new supply roll.
Check paper feed.
Adjust the label edge sensor.
(see Chapter 7)
Load new supply roll of transfer
ribbon.
Cancel the current print job.
Change the heat level via software,
clean the printhead, load transfer
ribbon, restart print job.
Cancel current print job.
Set software to direct thermal mode.
Restart print job.
Error message
No label found *
Out of paper *
Out of ribbon *
Table C-3 Error messages (continuation)