BYD e6A, Owner'S Manual

Page: 47 / 195

BYD e6A AUTO Owner's Manual
Doors and Keys 1-29
c. Hold the support rod end to pull the rod out
of the clip and then insert the rod end into
the hole in the front left section of the
motor hood.
To close the motor hood, lift it up slightly,
remove the support rod from the hole at the
hood and put it back into the clip. Lower the
hood and release it at a height approximately
30 cm above the fender panel to let it drop
freely.
Check that the latch is secured after closing
the motor hood.
Tips
Make sure that the hood is securely
supported by the support rod after the rod is
inserted into the groove, in order to prevent
physical injuries that could be caused by the
hood falling.
Anti-theft System
To prevent the car from theft, under anti-theft
status, if any door is opened the system will
give out alarm sound.
While the alarm system gives out sound, the
turn signal lights will flash.
System Settings
a. Shut down the motor.
b. All passengers shall get off.
c. Lock all doors.
When all doors are locked, the anti-theft
indicator will remains on. The anti-theft system
will be set up automatically after
10 seconds. The anti-theft indicator will flash
after the system is set up.
d. Make sure the indicator is flashing before
you leave the car.
If anyone in the car unlocks the door, the
anti-theft system will be activated. So do not
leave anybody in the car.
Activate Anti-theft System
The system will give out alarm sound in the
following cases:

Any door is unlocked when the
intelligent key access function is not
used.

The power supply is turned on when the
intelligent key starting function is not
used.
Support rod
Support rod end
Clip