BYD e6A, Owner'S Manual

Page: 182 / 195

BYD e6A AUTO Owner's Manual
5-22 Electric Appliance
Before Adding Cleanser
Pull out washer fluid funnel and hang it on the
motor hood support.
Water can be used as washer fluid. But in
cold region where the temperature is below
zero degrees, you must use washer fluid with
an anti-freeze agent. It is available in BYD
authorized service stations and most auto
part stores. For the mixing ratio of water and
anti-freeze agent, please refer to
manufacturer's instructions.
Put the funnel back in place after filling the
washer fluid tank.
Replace Bulb
The following figures shows the method to
remove the bulbs. Make sure the power
switch and light switches are turned off when
replacing bulbs. Use bulbs with rated power
shown in the table below:
Parking light and rear parking light consists of
a group of LEDs. When the number of burnt
out LED affects the vehicle's compliance with
local laws, please send the vehicle to BYD
authorized service station to replace bulbs.
Tips
●
Do not replace bulb when it is hot to
avoid burning.
●
The halogen bulb is filled with
pressurized gas, please be particularly
careful. If the bulb is scratched or falls to
ground, it may explode or crack. Only
hold the bulb on its plastic or metal part.
Do not touch the glass part of the bulb
with bare hands.
When traveling in rain or when the light lens is
wet after washing, the inside of lamp lens of
an external light such as a headlight will
temporarily fog. As with fog on the windshield
in rainy days, the fog inside the light lens is
due to the temperature difference between
the inside and the outside of light lens, and
isn't a problem. But if there is water droplet or
water pool in the light lens, please contact
BYD authorized service station.
Headlight
NOTICE
Only the bulbs specified in the following table
can be used.
Bulb W Type
Headlight (low beam) 55 H7
Headlight (high beam) 60 HB3
Front fog light 55 H3
Parking light 5 W5W