5 - 30
CNC AXIS MODULES
Edition 06.2005
5.4
Digital axis module SERC (continuation)
Status-
Meaning of the error messages
display
n
Configuration error (command / actual value channel)
With the configuration of the cyclic telegram data with the entries off the command - /
actual on errors actual value channels occurred.
Reaction by SERC
Phase resetting in communication phase 0.
A cause
There is too many is or actual value configures.
In the Y-0-0039 or Y-0-0040 actual the bit 15 settinged and in the Low byte the entered
length actual too largely.
Remedial action
Reduce you the number of cyclic data
(see parameter S-0-0016, S-0-0024 in the drives).
Reset you Y-0-0039 or Y-0-0040 or modify to you the length specification of the being
or actual value channel.
o
Error in the time slot calculation
With the calculation of the times for the SERCOS Transfer in phase 4 actual on errors
occurred.
Reaction by SERC
Phase resetting in communication phase 0.
A cause
The configured command soll-oder did not lstwerte become from at least one drive
supports (see parameter Y-0-0021 - to Y-0-0036), because the parameter number not
available actual or cannot be configured cyclically.
In SERC the command value generator was activated and an operating mode
adjusted for SERC automatically cyclic parameters to configure does not want, those
in the drive are available or cyclically to configure do not leave themselves. Thus
support e.g.. some drives the operating mode, drive-internal interpolation „ not.
Remedial action
It checks you whether the parameter entered in the suitable being actual value
channel from the drive for the cyclic over conference is certified.
Command value generator switch off or other operating mode select.
Summary of Contents for CONTROL SYSTEM 900
Page 13: ...1 12 INTRODUCTION Edition 12 2005 ...
Page 22: ...2 9 CHASSIS Edition 06 2005 2 3 Chassis measurement Chassis side view 4 186 5 247 18 5 284 ...
Page 177: ...8 12 ANALOG INPUT OUTPUT MODULES Edition 06 2005 ...
Page 258: ...10 49 OPERATING PANELS Edition 11 2005 10 8 Teachpanel continued ...