9 - 11
COMMUNICATION MODULES
Edition 03.2007
9.2
Active EtherNet connection ETH (continued)
Function
In PLC controls for the exchange of the data blocks and the user programs.
In CNC controls also for the management of the work piece programs.
Hardware construction
Connection of a 8-pin socket RJ45 (10BASE-T) for EtherNet.
Connections at the module:
-
Service
9pin socket of the BWO service interface
-
AUI
25pin socket for EtherNet
(only by ETH 084309)
-
BNC
(10BASE-2)
2pin socket for EtherNet
(only by ETH 084309)
-
RJ45
(10BASE-T)
8pin socket for EtherNet
Status and diagnostic display:
-
ST
Status display
-
BS
Read or write access of the internal processor
-
LK
Line section check by RJ45
-
TX
Module is transmitting
-
RX
Module is receiving
Summary of Contents for CONTROL SYSTEM 900
Page 13: ...1 12 INTRODUCTION Edition 12 2005 ...
Page 22: ...2 9 CHASSIS Edition 06 2005 2 3 Chassis measurement Chassis side view 4 186 5 247 18 5 284 ...
Page 177: ...8 12 ANALOG INPUT OUTPUT MODULES Edition 06 2005 ...
Page 258: ...10 49 OPERATING PANELS Edition 11 2005 10 8 Teachpanel continued ...