Bull NovaScale T840 E2, User Manual

Page: 55 / 210

User Guide
55
www.bull.com
Additional Parts for Future Use
Before You Begin
Before you begin, please review the following cautions, warnings, and general
guidelines.
Warning:
Be sure that power to the system is turned off and unplugged.
All voltage is removed only when the power cords are unplugged.
■
Avoid excessive vibration and shock. Dropping an electronic component can cause
serious damage.
■
Do not disconnect or remove parts other than those specified in the procedure.
■
Do not touch I/O connector pins.
■
All screws are Phillips-head, unless otherwise specified.
■
On completion of any assembly or reassembly, perform a power-on test. If a fault
occurs, verify that the assembly or reassembly was performed correctly. If the
problem persists, refer to
“Solving Problems” on page 148 .
Static Precautions
An electrostatic discharge (ESD) can damage disk drives, option boards, and other
components. You can provide some ESD protection by wearing an anti-static wrist
strap attached to chassis ground when handling system components.
Electronic devices can be easily damaged by static electricity. To prevent damage, keep
them in their protective packaging when they are not installed in your system.
Assembly
The following subsection describes how to assemble your rack-mount server into a
standard 19-inch rack cabinet.
Before you begin select an appropriate location in your rack cabinet for the rack-mount
server. To improve rack stability, mount heavier items towards the bottom of the rack
cabinet. If the rack is a stand-alone unit and the rack is more than 75% filled with
components, consider installing an optional stabilizer kit.
8 (minimum) screws TCB M5
8 (minimum) washers