Brunswick StringPin, Service Manual

Page: 90 / 126

4-4
Section 4: Adjustments
d. Push the Cam Control Box UP to rotate the cam as needed based on the operation
observed in step 2. Refer to Figure 4-4.
Figure 4-4. Adjust Bracket
(1) PINS UP SWITCH (2) SLIDE BRACKET UP IF (3) SLIDE BRACKET DOWN IF STRING
STRING WAGON TRAVELS WAGON DOES NOT LOCK ON STOP
PAST STOP DOGS DOGS
e. After the cam is adjusted in the proper direction, lower the cam down to align with gear
teeth. Refer to Figure 4-4. Tighten the four screws loosened in step 3c.
f. Toggle the Run/Stop switch from Stop to Run to cycle the pinsetter. Repeat switch
adjustment until string wagon locks interacts properly with the stop dogs.
g. Re-install the switch cluster cover removed in step 3b.