Brunswick StringPin, Service Manual

Page: 113 / 126

Section 6: Troubleshooting
6-1
Section 6 - Troubleshooting
Solutions to Common Problems
1. Machine and Accelerator Will Not Run
1. Check to see that the main switch is in the ON position.
2. Make sure the power cord is properly installed.
3. Check to ensure that the circuit breaker for the incoming power is not tripped or turned off.
2. One Machine Does Not Run
1. Make sure the motor stop switches on the Pinsetter for the non-running motor are turned ON.
2. Check for reported errors on the stringpin controller LCD display and confirm that all electrical
cables are properly installed.
3. Check to confirm that the de-tangle switch (under the cover at the front of the right hand
pinsetter side frame) is in the closed position.
4. Make sure the “V” belt for the drive motor is not off the pulley or broken.
3. Accelerator Will Not Run
1. Check the overload for the accelerator motor to make sure it is not tripped.
4. Machine Will Not Stop After Completing a Cycle
1. Check to see that the pinsetter ball detect is clean and properly adjusted.
2. Check the magnet on the Pin Motion Interface to verify it is not stuck in line with the reed
switch.
3. Check the Reset switch on the ball rack for proper operation.
4. Check the Home Switch for proper operation. Replace as needed.
5. Machine Starts and Stops When Attempting to Lift Pins
1. Make sure there are not any pins or strings that are caught or not moving freely.
2. One or more pin strings have excessive spring tension.
3. Improper spring tension on the pinsetter motor.
4. A replacement string has been improperly installed.
5. Watch the de-tangle switch to see if its actuator is functioning improperly.
6. Check de-tangle switch wiring.