BRP SEA-DOO Search and Rescue Series 2017, Operator'S Manual

Page: 82 / 164

OPERATING MODES
The operator can select an idle
speed set point (slow speed) be-
tween 1 and 5 (1.6 km/h to 11 km/h
(1 MPH to 7 MPH)).
If you accelerate above approximately
14 km/h (9 MPH), Slow Speed Mode
will be deactivated and the engine will
return to its normal idle RPM when the
throttle is released.
Should a situation arise where the op-
erator must stop or accelerate quickly
away from a hazardous situation, pull
in the iBR lever, or pull in on the throttle
lever to deactivate slow speed mode
and regain normal control of the water-
craft.
Activating Slow Speed Mode
To activate slow speed mode of opera-
tion:
1. Release the throttle lever to idle
RPM.
2. Pull in and release the iBR lever to
engage neutral.
3. Press and hold the cruise button for
approximately 1 second.
sdd2009-001-024_g
TYPICAL
1. CRUISE button
The CRUISE indicator will come on
in the multifunction gauge to indicate
cruise activation.
CRUISE MODE INDICATOR
A scrolling message will appear in the
multifunction display to specify that
you are now in slow speed mode. The
default slow speed set point of 1 will
also come on for a few seconds in the
numerical display.
1
2
FUNCTION SELECTED - SLOW
SPEED MODE
1. SLOW SPEED MODE message
2. Slow speed set point of "1" indication
NOTE:
The scrolling SLOW SPEED
MODE message repeats itself as long
as slow speed mode is activated. The
numerical display reverts back to the
previous indication after a few sec-
onds.
Changing Set Slow Speed
There are 5 slow speed set points avail-
able (1 through 5), 1 being the slowest.
To
increase
or
decrease
the slow
speed set point, press the UP/DOWN
button on the RH handlebar once, or
repeatedly.
80
______________
https://www.boat-manuals.com/