BRP SEA-DOO Search and Rescue Series 2017, Operator'S Manual

Page: 37 / 164

PRE-RIDE INSPECTION
WARNING
Never inflate sponson more than
41 kPa (6 PSI). Inflating sponson
more than the specified pressure
may damage sponson and cause
personal injury. Never use high
pressure to inflate sponson.
Rear Mast
Check condition of the rear mast and
its support.
Navigation Lights
Ensure all navigation lights are opera-
tional.
Engine Cut-Off Switch and Engine
START/STOP Button
Install the tether cord cap on the en-
gine cut-off switch.
Press the START/STOP button to start
the engine, then stop it by pressing the
START/STOP button a second time.
Restart the engine, then stop it by re-
moving the tether cord from the engine
cut-off switch.
WARNING
Should the tether cord cap be
loose or fail to remain on the en-
gine cut-off switch, replace the
tether cord immediately in order
to avoid unsafe use. If remov-
ing the tether cord cap from the
engine cut-off switch or pressing
the START/STOP button does not
stop the engine, do not use the
watercraft. See your authorized
Sea-Doo dealer.
What to Do After
Launching the Watercraft
Check the items listed in the follow-
ing table after launching the watercraft
and before going for a ride.
ITEM OPERATION ✓
Information
Center
Check operation
Intelligent Brake
and Reverse
System (iBR)
Check operation
Variable Trim
System (VTS)
Check operation
Information Center (Gauge)
1. Press START/STOP button and in-
stall the tether cord cap on the en-
gine cut-off switch.
2. As the information center cycles
through its self-test function, en-
sure all indications come on.
WARNING
Always attach the tether cord clip
to your PFD or to the wrist (wrist
strap required).
iBR System
NOTICE
Ensure there is sufficient
space ahead and behind watercraft
to safely carry out the iBR system
test to avoid a collision. Watercraft
will move during test.
1. Remove the moorings securing the
watercraft to the dock.
2. Start the engine and ensure the wa-
tercraft does not move.
3. On the left handlebar, depress the
iBR lever completely in, the wa-
tercraft should move slowly back-
wards.
4. Release the iBR lever, there should
not be any reverse thrust.
WARNING
Always ensure proper iBR system
operation before taking the water-
craft out for a ride.
________
SAFETY INFORMATION
________
35
https://www.boat-manuals.com/