BRP SEA-DOO Search and Rescue Series 2017, Operator'S Manual

Page: 68 / 164

OPERATING INSTRUCTIONS
If the watercraft is moving backwards,
momentarily press the UP button.
sdd2009-001-024_i
TYPICAL - TRIMMING THE iBR NEUTRAL
POSITION
1. UP button (to stop rearward movement)
2. DOWN button (to stop forward movement)
NOTE: Press the UP/DOWN button
repeatedly until proper adjustment of
the neutral position is attained and the
watercraft stops moving.
How to Engage Forward
To engage forward from neutral po-
sition, tap on the throttle lever. The
watercraft will accelerate forward.
To engage forward from reverse posi-
tion, release the iBR lever, then tap the
throttle lever.
To re-engage forward from braking, si-
multaneously pull in the throttle lever
while releasing the iBR lever. The wa-
tercraft will accelerate forward after a
short delay.
smo2009-002-201_b
TYPICAL - ENGAGING NEUTRAL
1. Throttle lever
How to Engage and Use
Reverse
Reverse can only be engaged between
idle speed and the threshold forward
speed of 8 km/h (5 MPH).
To engage reverse position, the iBR
lever on the LH handlebar must be
pulled in at least 25% of the lever
travel.
smo2009-002-202_a
TYPICAL - iBR LEVER
1. iBR lever
2. Lever released position
3. Approximate 25% position
4. Operating range
When operating the iBR lever in re-
verse mode, the throttle lever can
be used to control engine RPM, and
thus the amount of reverse thrust pro-
duced.
By modulating both the iBR and throt-
tle levers simultaneously,
reverse
thrust can be more precisely con-
trolled. Too much RPM will create
water turbulence and reduce reverse
efficiency.
NOTE: Engine power will be reduced
to idle whenever the iBR lever position
is changed.
Release the iBR lever to end reverse
operation.
To stop rearward motion after iBR lever
release, apply enough throttle to stop
rearward movement.
WARNING
The brake function has no effect
when travelling in reverse.
66
______________
https://www.boat-manuals.com/