BRP Outlander 400 EFI 2008, Service Manual

Page: 313 / 434

Section 06 ELECTRICAL SYSTEM
Subsection 04 (LIGHTS, GAUGE AND ACCESSORIES)
vmr2006-020-071_b
SWITCH
POSITION
WIRE TERMINAL
AT RELAY
VOLTAGE
Switch pressed
to OUT and held
BLUE/
GREEN
Chassis
ground
Battery
voltage
vmr2006-020-071_c
If voltage is not read in either test, carry out a
continuity test of the winch control switch further
in this section.
If voltage is read in both tests, test winch relay as
follows.
Winch Relay Voltage Drop
Reconnect terminals at winch relay.
Measure voltage drop across relay contacts as fol-
lows.
WINCH RELAY VOLTAGE DROP
SWITCH
POSITION
RELAY TERMINALS
VOLTAGE
DROP
Switch pressed
to IN and held
Battery
post (RED
cable)
IN cable
to winch
motor
0.2 Vdc
max.
vmr2006-020-074_b
POSITION RELAY TERMINAL
VOLTAGE
DROP
Switch pressed
to OUT and held
Battery
post (RED
cable)
OUT cable
to winch
motor
0.2 Vdc
max.
vmr2006-020-074_a
If voltage drop is higher than specification in ei-
ther test, check wiring/connectors. If wiring/con-
nectors are good, replace winch relay.
If voltage read is battery voltage, the relay does
not close. Replace winch relay.
D5 and D6 Diode Test
NOTE: Refer to WIRING DIAGRAM .
Remove the front steering cover. Refer to the
BODY
section.
Disconnect winch switch connector, see previous
illustration.
Disconnect the GREEN/BLUE wire going to winch
relay (GREEN on relay).
Disconnect the BLUE/GREEN wire going to winch
relay (BLACK on relay).
314
vmr2008-140