BRP Outlander 400 EFI 2008, Service Manual

Page: 273 / 434

Section 06 ELECTRICAL SYSTEM
Subsection 02 (CHARGING SYSTEM)
vmr2008-138-009_a
1. Pull back RED rubber boot
2. Disconnect RED (+) battery cable
Pull back the red rubber boot and disconnect the
RED (+) battery cable.
Remove battery from support.
If replacing battery, remove the battery insulator
pad.
vmr2008-138-011_a
1. Battery insulator pad
Battery Cleaning
With the battery removed from vehicle, clean
the battery rack, insulator pad, cables and battery
posts using a solution of baking soda and water.
Remove corrosion (if present) from battery cable
terminals and battery posts using a firm wire
brush. Rinse thoroughly with clear water and dry
using a clean cloth.
Apply a light coat of dielectric grease (P/N 293 550
004) on terminals.
Battery Inspection
Visually inspect battery casing for cracks or any
other damages. If casing is damaged, replace bat-
tery and thoroughly clean battery support with a
water and baking soda solution.
Inspect condition of battery posts, battery sup-
port, holding strap and strap attachment points
and wire terminal lugs.
Battery Storage
It is not necessary to remove the battery during
vehicle storage but it is recommended for long
term storage.
If the battery is left in the vehicle during storage or
used infrequently, disconnect the BLACK (-) nega-
tive battery cable to eliminate battery current drain
from the electrical equipment.
Recharge the battery once a month with an ap-
proved battery charger as per manufacturer's rec-
ommendations.
Clean battery, battery support and connections as
required, refer to
BATTERY CLEANING
in this sec-
tion.
For other recommendations during storage, refer
to battery manufacturers instructions.

WARNING
Ensure battery is stored in a safe place, out of
reach for children.
New Battery Activation
Refer to the instructions provided with the battery.
Battery Charging

WARNING
Always wear safety glasses and charge in a
well ventilated area. Never charge or boost a
battery while it is installed on vehicle. Do not
open the sealed cap during charging. Do not
place battery near open flame.
CAUTION: If battery becomes hot, stop charg-
ing and allow it to cool before continuing.
NOTE: Sealed VRLA batteries have an internal
safety valve. If battery pressure increases due to
overcharging, the valve opens to release excess
pressure, preventing battery damage.
Perform a
BATTERY UNLOADED TEST
.
An automatic charger is a fast and convenient way
for error-proof charging.
Always follow the battery manufacturers charging
instructions.
Battery should be charged at a slow charge rate of
1/10 its given 10 hours. capacity.
vmr2008-138
273