BRP Evinrude E-TEC, Manual, Page: 42 / 364

42
Routine Service
Lubrication
•
Tilt the outboard and engage the tilt support.
•
Remove filler cap and check fluid level.
•
Single Ram System –Add Evinrude/Johnson
Biodegradable TNT Fluid, as needed, to bring
level to the bottom of the fill plug threads.
Install the filler cap and tighten to a torque of 45 to
55 in. lbs. (5 to 6 N·m).
•
Disengage tilt support.
•
Cycle the unit at least five complete cycles to
purge all air from the system. When cycling the
unit, hold the trim switch ON an additional 5 to
10 seconds after the unit reaches the end of its
travel before activating the switch in the oppo-
site direction.
1. Tilt support bracket, 2-cylinder models 18954
1. Tilt support bracket, 3-cylinder models 002279
1
1
Single Ram System, 2-Cylinder Models
1. Filler cap
008018
Single Ram System, 3-Cylinder Models
1. Filler cap
008017
1
1