BRP Evinrude E-TEC, Manual

Page: 20 / 364

20
Routine Service
Outboard Rigging Connections
Outboard Rigging Con-
nections
IMPORTANT:
For complete outboard rigging
and remote control installation information, refer to
the
Predelivery and Installation Guide included
with the service manual set.
Common Practices – All Models
Control Cable Identification
IMPORTANT:
Identify control cable function be-
fore rigging outboard.
Identify each control cable:
•
Put the control handle into NEUTRAL position.
The throttle cable casing guide will retract com-
pletely and the shift cable casing guide will go to
the midpoint of its travel.
Extend the control cables and lubricate them with
Triple-Guard grease.
Cable Retainer Clip Installation
When installing retainer clips on control arm link-
age pins, clips should be locked and
must not be
bent or deformed.
For proper installation, review the following steps:
•
Place washer on pin.
•
Position retainer clip with straight section on the
bottom and angled section on the top.
•
Use long nose pliers to insert straight section of
clip into linkage pin hole.
•
Push the clip towards the hole while lifting on
the curved end with the pliers.
•
Be sure retainer clip fully engages the pin.
•
Lock the retainer by moving the angled section
behind the straight section.
1. Shift cable casing guide extended to midpoint
2. Throttle cable casing guide retracted
DP0811
30501
2
1
1. Straight section
2. Angled section
010302
Locked Retainer Clip
1. Angled section behind straight section
010303
1
2
1