BRP Evinrude E-TEC, Manual

Page: 171 / 364

171
Oiling System
Oil Control Settings
8
•
Use the diagnostics software to start break-in
oiling after a powerhead rebuild.
Oil Supply Priming
Start the outboard. Use the oil priming function in
the software to make sure the system is com-
pletely primed.
Use the Prime Oil System button of the Dynamic
Test screen to prime the oil pump.
Observe oil flow through all oil distribution hoses.
Air must be purged during the priming procedure.
Small bubbles are acceptable. Large bubbles
must be eliminated through continued priming.
Repair any fuel or oil leaks.
The oiling system on these models can also be
primed using the Self-Winterizing feature if diag-
nostics software is not available. Refer to
Storage
on p. 50.
1. Break-in oil setting 008580

WARNING
Always use caution while working around
machinery with moving parts. The following
set-up procedures require running tests that
are performed with the outboard’s motor
cover removed.
Dynamic Test Screen
1. Prime Oil System button
008570A
1
1
1. Oil distribution hoses 007997
1. Oil distribution hose
2. Small bubbles
3. Large bubbles
004398
1
1
3
2