rmo2010-001-005
6. Carefully remove cap. Pay attention not to drop
the cap seal.
7. Look inside the reservoir to see the fluid level.
8. Check clutch fluid level inside the reservoir:
– The fluid must be flush to the fill level line
(protuberance on the reservoir wall).
rmo2010-001-006_b
FLUID REMOVED FOR CLARITY PURPOSE
1. Fill level line
9. Add recommended fluid as required.
Do not
overfill.
WARNING
Avoid getting brake fluid on skin or in eyes
— it may cause severe burns. In case of con-
tact with the skin, wash thoroughly. In case
of contact with the eyes, immediately rinse
with plenty of water for at least 10 minutes
and then consult a doctor immediately.
10. Immediately wipe up spills if necessary.
11. Ensure that the seal located inside the cap is
collapsed.
12. Reinstall the cap to the reservoir.
13. Tighten cap screws.
14. Wipe off reservoir if necessary.
Engine Coolant
WARNING
When opening the reservoir, the coolant can
be very hot and spray out if the engine is
hot. In order to avoid getting burned, check
coolant level when engine is cold.
Recommended Coolant
The cooling system must be filled with distilled
water and antifreeze solution (50% distilled water,
50% antifreeze).
For best performance,
use
BRP
PREMIXED
COOLANT (P/N 219 700 362)
Coolant Level Verification
WARNING
When opening the reservoir, the coolant can
be very hot and spray out if the engine is hot.
In order to avoid getting burned, check the
coolant level when the engine is cold.
1. Park the vehicle on a firm, level surface.
2. Open the front storage compartment.
3. Remove the plastic rivet from the right service
cover.
rmr2010-038-021_a
1. Right service cover
2. Plastic rivet
4. Pull down the service cover using the recess to
release upper tabs from the front fascia.
SERVICE
2013-2
25 / 47
