rmo2008-001-102
Licence Plate
NOTE:
When a license plate needs to be installed
or replaced, ensure to install new damping pad
(P/N 293 740 028).
1. Remove existing plate on vehicle (if applicable).
2. Peal off backing of new damping pad.
rmo2008-002-509_a
1. Damping pad backing
3. Position new damping pad on vehicle plate sup-
port.
rmo2010-001-053_a
1. Plate support
4. Secure upper portion of license plate on vehicle
plate support using existing hardware.
rmo2010-001-054_a
1. Existing hardware
5. Squeeze license plate and support together at
the center.
Accessories Installation
1. Install accessories (if any) as per their installa-
tion instructions (included in each kit).
2. Install any other equipment required by law (if
any).
Vehicle Decals
1. Install decals on vehicle according to customer
country language and local legislation.
2. Ensure that the new decals are installed at the
same location and over the factory installed de-
cals.
Key Barrel - Trailer RT 622
An extra key barrel is supplied with each Spyder
RT. This allows the use of the vehicle key for the
trailer.
Refer to the trailer RT 622 PDI Bulletin for all the
details.
FLUIDS
General Guidelines
All fluids (except fuel) have already been filled
at factory, it is only necessary to validate them.
However, if refill is needed, refer to the appropri-
ate
ROADSTER SHOP MANUAL
for the proper
procedure.
Fuel
1. Unlatch and lift seat.
2. Add fuel in the fuel reservoir.
22 / 47
2013-2
SERVICE
